Hello, I recently went through the DCNIS-2 training course and got a ticket from a client stating that he had some trouble with a 2148T which failed and restarted. If I run the commands "show system reset reason" and "show diagnostic result fex xxx" I get that there was no real reason for restarting and that physically all ports are OK nonetheless when I issue the command "show fex detail xxx" I can't seem to locate ports in the range of 42 to 48.
Ok, when I said "I issue and I run the commands" I was trying to refer to our client which hasn't given me access to conifguration.
So the final question is... the ports that are not showing in the "show fex detail" could be part of some vPC? is there any explanation to this because port pinning is set to 1.
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does