if i need to port channel hp servers with 4 nic cards to two nexus 2k. ( i understand that nexus 7k dont support port channel on multiple fex)
so i have created two port channel on nexus (nexusk 2k1 - port chanel 1 and nexus 2k2 port channel 10) and connected ports 1 and 2 of server to nexus 2k1 and 3 and 4 ports of servers to nexus 2k2
if i need to port channel on server side do i need two port chanel or a single port channel on server? i would like to use the entire 4gig as a single team on the server with load balancing and redundancy if possible or what are the best options ?
802.3ad Dynamic with Fault Tolerence
Switch-assisted load balancing with Fault Tolerance (SLB)
Transmit load balancing with Fault Tolerance (TLB)
Transmit Load Balancing with Fault tolerance and preference order
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...