I was looking at the part numbers on the Data Sheet for the new Nexus 5000 series switches. The part numbers are interesting in that there are numbers for the chassis, Power Supplies, Fans, Software, Software Licenses, Expansion Modules, Cables and Optics, and Power Cords. I did not see on the Data Sheet any "bundle" Part Numbers.
Does anyone have any expertise on these switches? Does Cisco offer any bundles?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...