Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NEXUS N5k - Reload vs Reload power-cycle

Hello,

An easy question... What is the difference between these three reload modes ?

- reload

- reload all

- reload power-cycle

Thank you...

Regards

Ju

Everyone's tags (2)
2 REPLIES
Cisco Employee

NEXUS N5k - Reload vs Reload power-cycle

Hi Ju,

N5# reload ?

 

  all          Reboot the entire box and Fex Modules >>>>>>>> Reloads the switch + FEX's

  fex          Reboot Fex

  power-cycle  Power cycle ADM >>>>>>>>>> This has the same affected as powering Off the switch (turning off the power supplies) followed by On, i.e. toggling the power to the switch. Is required following upgrades where firmware for the power-sequencer is upgraded:

http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/upgrade/503_N1_1/n5k_upgrade_downgrade_503.html#wp640973

The default reload option only reloads the switch, certainly if FEX's are single homed they too undergo reset, however incase of Dual homed FEX's they continue being attached to the peer switch in vPC.

HTH!

Regards,

Deepak

New Member

Cisco mentioned 

Cisco mentioned 

"After a successful power sequence upgrade, you must switch off the power to the system and then, power it up."

What's the complication if we do not hard power-cycle the nexus after Bios/power-sequence is upgrade? There is lack of Cisco documentations. 

3691
Views
0
Helpful
2
Replies
CreatePlease to create content