Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nexus vPC : vpc orphan-port suspend

Hi, in vPC configuration in case of dual-active the secondary vPC-peer susends all it vPC-Ports.
In addition to that its possible to suspend the orphan-ports (which are not connected via vPC) as well by configuring under the interface

http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_vPC.html#wp1835751

vpc orphan-ports suspend

which is a very helpful command for example if you have connected one armed FWs to the Nexus.

Unfortunately there is no way to run this command on port-channel interfaces, just on physical one.
Its also not posisble to configure it on the physical interfaces which are member of a port-channel.

Is there a way to achive it on orphan port-channels as well ??

Thx in Advance

Hubert

6 REPLIES
Silver

Nexus vPC : vpc orphan-port suspend

I ran into the same issue; it works only on physical interfaces.

New Member

Nexus vPC : vpc orphan-port suspend

Did ounopen a SR or isnt it supported ?

KR

Hubert

Silver

Nexus vPC : vpc orphan-port suspend

No, we just tried to apply the command on physical interfaces and it behaved correctly.

New Member

Nexus vPC : vpc orphan-port suspend

Hi hubert,

i test putting vpc orphan-port suspend first then put the channel-group config.

it works as expected.

i am not sure if this is a bug or not supported config.

have you found a solution?

New Member

Nexus vPC : vpc orphan-port suspend

Hi Folks,

vpc orphan-ports suspend is only supported on physical interaces & not on port-channels.

To have this mentioned in the CCO doc, there is already a bug filed.

Bug id id CSCua54988.

HTH,

Rakesh

New Member

Nexus vPC : vpc orphan-port suspend

Confirming this behavour on 5548UP running NX-OS 5.2(1)N1(3)

1/30 is a normal access port, 1/13 is a member of a non-vpc port-channel.

5548UP(config)# int e 1/30
5548UP(config-if)# vpc ?
  orphan-port  Orphan-port (non-vpc port)

5548UP(config-if)# vpc orphan-port ?
  suspend  Suspend - when vPC secondary peerlink goes down

5548UP(config)# int e1/13
5548UP(config-if)# vpc ?
*** No matching command found in current mode, matching in (config) mode ***
  bind-vrf  Bind vrf
  domain    Specify domain

1826
Views
0
Helpful
6
Replies
CreatePlease login to create content