You need to manually add an ARP entry to the L3 pointing at the virtualized MAC of the NLB. Because it is using a multicast MAC for the NLB the L3 device will not cache the Unicast IP associated with that MAC and therefore can't route any traffic properly.
Use the following example to add static ARP:
arp X.X.X.X XXXX.XXXX.XXXX ARPA
(where X.X.X.X is the NLB IP and XXXX.XXXX.XXXX is the NLB MAC
You may need to add a static CAM entry too to map the NLB MAC to the proper ports...see the following articles and you should be g2g. Let me know if this helps.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.