NM-HDV2-2T1/E1 does not accept 120 channels with VWIC-2MFT-E1
I need to have 120 channels on my CISCO2851.
I am using NM-HDV2-2T1/E1 with two (2) built in E1 interfaces and one VWIC slot where I inserted a VWIC-2MFT-G703 to have a total of four (4) E1 interfaces.
The problem is that I can't create more than 60 time-slots channel for overall ports. When trying to configure the VWIC-2MFT-G703 daughter card, I got the following message
Router(config-controller)#channel-group 1 timeslots 1-31 %Insufficient resources to create channel group test(config-controller)# *Jan 11 14:51:13.539: %HDLC32-4-NOHDLCCHANNEL: HDLC32 in slot 1: No HDLC channel available
It's precised on the NM-HDV2-2T1/E1 datasheet that VWIC2-2MFT-G703 is supported and a maximum of 120 time-slots channel can be created
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.