Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NM16ESW with HWIC-4ESW IN 2811 CHASSIS

Hello,

I would like to know if some configuration exists so that these two cards work simultaneously. Since only HWIC works me. And when I remove HWIC it works me the NM-16ESW.

I ignore if you can configure a stack among both cards, or other solution.

Thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NM16ESW with HWIC-4ESW IN 2811 CHASSIS

Intra-chassis stacking is not possible with these two modules. You can run an ether-port from each module and cofigure it as a dot1q trunk in order to have ports in the same domain and configure them accordingly.

http://www.cisco.com/en/US/prod/collateral/routers/ps5853/prod_qas0900aecd8016c026_ps5854_Products_Q_and_A_Item.html

HTH,

-amit singh

3 REPLIES
Purple

Re: NM16ESW with HWIC-4ESW IN 2811 CHASSIS

If you want both I believe you have to stack the cards together in order for both to work otherwise you can only have 1 installed . Do a search on the main page for stacking those hwics togther.

New Member

Re: NM16ESW with HWIC-4ESW IN 2811 CHASSIS

The problem is that the stack between two model different from cards not you if it is possible. Since serious a stack with one HWIC-4ESW and NM-16ESW.

Thanks

Cisco Employee

Re: NM16ESW with HWIC-4ESW IN 2811 CHASSIS

Intra-chassis stacking is not possible with these two modules. You can run an ether-port from each module and cofigure it as a dot1q trunk in order to have ports in the same domain and configure them accordingly.

http://www.cisco.com/en/US/prod/collateral/routers/ps5853/prod_qas0900aecd8016c026_ps5854_Products_Q_and_A_Item.html

HTH,

-amit singh

438
Views
0
Helpful
3
Replies