Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

no 802.1x interface commands on 3560 switch

I am trying to configure 802.1x wired on a 3560 switch and don't see the required commands under the interface. Does anyone no why this would be? I am running c3560-ipbasek9-mz.122-55.SE6.bin. I was thinking it might not be available on the ipbase image, but I do have the commands on a 3750g running the ipbase image, so I'm not sure about that.

Thank you,

Mark                  

Everyone's tags (2)
4 REPLIES
Purple

no 802.1x interface commands on 3560 switch

Hi,

take a look at this:http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_55_se/configuration/guide/sw8021x.html

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
Bronze

no 802.1x interface commands on 3560 switch

Found out that you have to have the interface command "switchport mode access" configured in order to get the authentication or dot1x commands to show up.

New Member

no 802.1x interface commands on 3560 switch

Hi

You must to have enabled AAA on the Switch, and the Authentication method too.

Here is a simple Dot1x configuration.

SW# configure terminal

SW(config)# aaa new-model

SW(config)# dot1x system-auth-control

SW(config)# aaa authentication dot1x default group radius

SW(config)# interface fastethernet0/1

SW(config-if)# switchport mode access

SW(config-if)# dot1x port-control auto

SW(config-if)# end

Hope this be usefull,  let me know if you still haven´t the command.

Bronze

no 802.1x interface commands on 3560 switch

Carlos,

I had everything else that was available to configure. I just didn't have "switchport mode access" configured on the interface. Without that command the authentication and dot1x commands are not available.

Mark

1159
Views
0
Helpful
4
Replies