Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

No Access to 3750 Console

I'm using Secure Crt for console access to all cisco devices. This morning i can no loger communicate with cisco 3750's through console port, i tried on 3 different 3750's with same result. That same secure crt set up worked fine with firewall and switches. Any clues of what is wrong? Thx.

4 REPLIES

Re: No Access to 3750 Console

Check the cable connection, try putty or hyperterminal.

Perhaps it may be also a problem on your pc, reboot that one as well.

On hyperterminal click on DEFAULT for the serial connection settings.

Re: No Access to 3750 Console

Make sure that you're actually at the default speed of 9600 baud. Try different speeds etc.

HTH,

John

HTH, John *** Please rate all useful posts ***
Purple

Re: No Access to 3750 Console

If you have rebooted since using it on the firewalls and you are using a usb connector check to make sure the pc didn't use a different com port when it rebooted.

New Member

Re: No Access to 3750 Console

undocked the laptop Secure Crt re-acted funny :-), I tried using the Hyperterm and it works fine. Thanks everyone.

457
Views
0
Helpful
4
Replies