Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No ifIndex table when querying via SNMP

Hello, looking for suggestions before opening up a TAC case.

Just received a Nexus 3000 with NX-OS 6.0(2)U2(1) and when I attempt to walk the ifTable via SNMP the ifIndex table is not present. Walking the ifIndex table itself results in  "IF-MIB::ifIndex = No Such Instance currently exists at this OID". show interface snmp-ifindex is fine and the rest of the ifTable displays properly.

My switch config is just a basic RO community with no ACL's or anything yet. A pair of the same switches with NX-OS 5.0(3)U5(1a) display the table no problem.

Any suggestions, or has anyone else seen this?

Everyone's tags (3)
150
Views
0
Helpful
0
Replies