Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No input and output

Hi ALL:

I see the last input and 30 sencond input and output as 0.

What my understandinig is since CEF is enabled the packet are not hitting the CPU and thats why i dont see any input and output.

Is that right or i am missing something.

This is 4507r with Sup V-10GE .

GigabitEthernet7/16 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet Port, address is 001f.9e46.a67f (bia 001f.9e46.a67f)

Internet address is x.x.x.x

MTU 1500 bytes, BW 4096 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000-TX

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output never, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

30 second input rate 0 bits/sec, 0 packets/sec

30 second output rate 0 bits/sec, 0 packets/sec

L3 in Switched: ucast: 488526834 pkt, 57240662759 bytes - mcast: 0 pkt, 0 bytes

L3 out Switched: ucast: 530401074 pkt, 374322172171 bytes - mcast: 0 pkt, 0 bytes

488561771 packets input, 67080948138 bytes, 0 no buffer

Received 34128 broadcasts (0 IP multicasts)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

530439677 packets output, 384140361152 bytes, 0 underruns

101 output errors, 15 collisions, 0 interface resets

0 babbles, 101 late collision, 0 deferred

0 lost carrier, 0 no carrier

Chao

Vishwa

2 REPLIES
New Member

Re: No input and output

If you have traffic on the interface you should see input and output rate regardless of cef. Do a clear counters, put on a extended ping on the connected equipment on that interface and you should see the rate.

New Member

Re: No input and output

Hi Gunnar,

Thanks for the reply.

I have done that and there is traffic but i only see increase in L3 packets no increase in Input and output , any idea why is this happenning.

Chao

Vishwa

145
Views
0
Helpful
2
Replies