Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

no ip igmp snooping ? no explicit-tracking

hello!

i dont have this :explicit-tracking

DS2(config-if)#no ip igmp snooping ?

fast-leave Enable IGMP fast leave processing

last-member-query-interval Configure IGMP leave query timeout

mrouter Configure an L2 port as a multicast router port

querier Enable IGMP querier processing

ssm-safe-reporting Enable SSM Safe Reporting

static Configure an L2 port as a member of a group

<cr>

i dont have this :explicit-tracking::: on my 720:s72033-ipservicesk9-mz.122-18.SXE6a.bin

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: no ip igmp snooping ? no explicit-tracking

try the command under the interface.

6 REPLIES
Hall of Fame Super Bronze

Re: no ip igmp snooping ? no explicit-tracking

Hi Ali,

What's the problem you are trying to address here ?

New Member

Re: no ip igmp snooping ? no explicit-tracking

hello !

i have to disable "no ip igmp snooping explicit-tracking" but i didn't find the "explicit-tracking" i have strange brodcast.

10xs

Hall of Fame Super Bronze

Re: no ip igmp snooping ? no explicit-tracking

Try

no ip igmp explicit-tracking instead.

Also, Explicit host tracking is supported only with IGMPv3 hosts. Are you running IGMPv3 in your hosts ?

New Member

Re: no ip igmp snooping ? no explicit-tracking

no

New Member

Re: no ip igmp snooping ? no explicit-tracking

Still no:

(config)#no ip igmp ?

immediate-leave Leave groups immediately without sending last member query, use

for one host network only

limit IGMP limit

snooping Global IGMP Snooping enable for Catalyst Vlans

ssm-map SSM mapping commands

vrf Select VPN Routing/Forwarding in

the is no explicit-tracking

Hall of Fame Super Bronze

Re: no ip igmp snooping ? no explicit-tracking

try the command under the interface.

238
Views
10
Helpful
6
Replies