This one I can't understand. I have a 7301 with three gigabit ethernet interfaces where one of the interfaces is my "inside interface". My previous IOS was 12.3(5) and I had configured a netflow destination, version and had ip route-cache flow set on all three interfaces.
After the upgrade I replaced route-cache flow on all interfaces with ip flow ingress and egress. The problem now is that I only get netflow data from the traffic on two of my interfaces, netflow from my "inside" interface is missing.
The only difference between the three interfaces is that the "inside" interface has no access-list configured.
When I run show ip cache flow I see entries from traffic sent to the "inside" interface. Why isn't this passed on to the netflow destination?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...