Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

no poe on 6548 blade in a 6509 switch

Poe was working fine until this weekend. The ports work fine, but no poe on 3 out of 4 6548 blades. 3 works fine, but 2,4 and 9 has no poe. Show power is indicating everything is ok. We have moved one 6548 blade to a vacant slot. Trouble followed the blade. We are receiving a minor error on the modules. I have attached show ver, show power and show module. Any help would greatly be appreciated. We are completely down. I have also replaced the power supplies and changed them to combined mode.

1 REPLY
Hall of Fame Super Bronze

Re: no poe on 6548 blade in a 6509 switch

More than likely a hardware issue. Please open a TAC case immediately.

__

Edison.

212
Views
0
Helpful
1
Replies