Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NON-STP Enabled Ethernet Switch Ring.

Hi guys. We had a very interesting occurance happen about a week ago. We had a network congestion which seemed to have been caused by a non-stp enabled ethernet ring.

My question to you is, how long would it take for the link to be fully congested running at 256Mbps?

The diagram below is exactly correct, It's 1 switch port in, 1 switch port out.

http://img441.imageshack.us/img441/2317/nostp.png

1 REPLY
New Member

Re: NON-STP Enabled Ethernet Switch Ring.

Wow this forum moves fast

My post was on the 2nd page by 12:00pm hehehe..

302
Views
0
Helpful
1
Replies