Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

not able to configure ''switchport trunk encapsulation dot1q''

on WS-X6148-GE-TX module installed in 6509

related information :

#sh module

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL10436BBF

2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL104369DS

3 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL10436BCD

4 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL104369E9

5 3 Supervisor Engine 32 10GE (Active) WS-SUP32-10GE-3B SAL1020NDWX

6 3 Supervisor Engine 32 10GE (Hot) WS-SUP32-10GE-3B SAL1020NDYA

7 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL11466XUY

8 48 48 port 10/100/1000mb EtherModule WS-X6148-GE-TX SAD075100U2

SWE(config)#int Gi 8/15

SWE(config-if)#switchport mode trunk

SWE(config-if)#switchport trunk enca

SWE(config-if)#switchport trunk ?

allowed Set allowed VLAN characteristics when interface is in trunking mode

native Set trunking native characteristics when interface is in trunking mode

pruning Set pruning VLAN characteristics when interface is in trunking mode

Swe(config-if)#switchport trunk

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: not able to configure ''switchport trunk encapsulation dot1q

Sanjay

The WS-X6148-GE-TX only supports 802.1q encapsulation and that is why you do not have the CLI option to set encapsulation.

Jon

2 REPLIES
Hall of Fame Super Blue

Re: not able to configure ''switchport trunk encapsulation dot1q

Sanjay

The WS-X6148-GE-TX only supports 802.1q encapsulation and that is why you do not have the CLI option to set encapsulation.

Jon

New Member

Re: not able to configure ''switchport trunk encapsulation dot1q

Jon

Thanks for the prompt response.Actually

i have one migration activity sceduled

in this week, I have to connect HP blade

centre on the 6509 switch. The physical

connection needs to be done with WS-X6148-GE-TX module

Thanks again !

743
Views
0
Helpful
2
Replies
CreatePlease to create content