Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

not able to ping new 6506-E

Dear all,

One of our customer got 6506-E chassis but not able to ping it except its default vlan range , please help

Thanks,
AS

Sent from Cisco Technical Support iPhone App

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

not able to ping new 6506-E

AS

So you have 4 vlans that are created on the 6500 with L3 SVIs and you cannot ping them ?

If the 2960 is acting as L2 do you have this command -

ip default-gateway 192.168.100.1 

if the 2960 is doing any inter vlan routing then instead of the above -

ip route 0.0.0.0 0.0.0.0  192.168.100.1

all four vlans must be allowed across the trunk link.

Jon

7 REPLIES
Hall of Fame Super Silver

not able to ping new 6506-E

AS

There is not enough information here for us to be very helpful.

When you say except its default vlan range what does this mean?

Are you saying that they can ping some address but not others? In that case you need to provide some additional information about what does work and what does not work.

HTH

Rick

New Member

Re: not able to ping new 6506-E

Sorry for not giving more info.
Default vlan range is 192.168.100.0/24, a 2960 switch is connect to it via trunk IP is 192.168.100.2, 6506-E IP address is 192.168.100.1, 5 vlans are created, I am able to ping 6506 from 2960 switch but not able to ping from rest of 4 vlans IP range.


Sent from Cisco Technical Support iPhone App

Hall of Fame Super Silver

not able to ping new 6506-E

AS

Are you doing the ping from the 2960 switch or from some device connected to the switch?

HTH

Rick

Hall of Fame Super Blue

not able to ping new 6506-E

AS

So you have 4 vlans that are created on the 6500 with L3 SVIs and you cannot ping them ?

If the 2960 is acting as L2 do you have this command -

ip default-gateway 192.168.100.1 

if the 2960 is doing any inter vlan routing then instead of the above -

ip route 0.0.0.0 0.0.0.0  192.168.100.1

all four vlans must be allowed across the trunk link.

Jon

Hall of Fame Super Blue

not able to ping new 6506-E

AS

Rick makes a good point. I assumed you were trying to ping from the switch but if you are pinging from clients my advice is not necessarily applicable.

Jon

New Member

Re: not able to ping new 6506-E

You do not mention any router configured between the vlans/networks?
Is this the 6506? Or an external router?

If neither then you need to configure the 6506 with an adress on each vlan and enable ip routing

Sent from Cisco Technical Support iPad App

New Member

Re: not able to ping new 6506-E

Thanks for your response problem is resolved by giving default route to 192.168.100.1

Sent from Cisco Technical Support iPhone App

129
Views
0
Helpful
7
Replies