Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Not getting sh platform health in cisco 6513-Reg

Dear All,

In cisco 6513 switch, i cant able to view sh platform health command..What i have to do for showing that command?

As well as i have planned to creat access group to one of the port which is connected to the  main ftp  server..

When ever i am applying that command, our network will be going to unreachable.

i.e

int access-list extend ftp

permit tcp host 10.234.137.32 host 10.234.16.1(Server IP)

int gi4/17

ip access-group ftp in

Anything i have to do in that?..Pls.Guide me

Tks&Rgds

Senthil

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Not getting sh platform health in cisco 6513-Reg

Hello Senthil,

The "show platform health" specific for c4K platform and does not apply to c6K.

Understand the show platform health Command on the Catalyst 4500 Switches:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtml#understand2

Regards,

Sergei

1 REPLY
Cisco Employee

Re: Not getting sh platform health in cisco 6513-Reg

Hello Senthil,

The "show platform health" specific for c4K platform and does not apply to c6K.

Understand the show platform health Command on the Catalyst 4500 Switches:

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtml#understand2

Regards,

Sergei

459
Views
0
Helpful
1
Replies
CreatePlease to create content