Novell Clients use SLP (Service Location Protocol) in order to find servers/services over IP.
SLP relies on multicast for client/server and server/server communication.
What you are seeing is normal. If you want to configure the client to communicate over to the server in a routed environment, you must configure Directory Agent at the server and specify the DA in the client properties.
More information regarding this setup can be obtained by asking in the novell support forums.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...