Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NPE-300 7206VXR boot failure

Hi,

I am getting following error when I boot 7206VXR router with NPE-300 from rommon

*** Bus Error (Load) Exception ***

Access address = 0x826e5bc1

PC = 0x8000af3c, Cause Reg = 0x1c, Status Reg = 0x3040d003

monitor: command "boot" aborted due to exception

Please advice.

Thank you,

Tresa

3 REPLIES
New Member

Re: NPE-300 7206VXR boot failure

Try a different IOS image to start with, see if you can get anywhere with that. Might also be an issue with the boot media.

New Member

Re: NPE-300 7206VXR boot failure

Hi,

You mean issue with flash ?

Could it be a problem with I/O controller ?

or could it be a problem with boot loader image. Only somtimes this error is dispalyed when booting from rommon. The booting is not booting with IOS image . No error message I am getting at that time. The booting stops and by break sequence I can enter rommon and boot with same IOS I have given in boot system command.

Thanks,

Tresa

New Member

Re: NPE-300 7206VXR boot failure

I've seen a problem very similar to that before and I think it's related to the flash disk, but I'm not 100% sure. If you have the time/ability I'd try either formatting and reloading the IOS onto the flash or trying a new disk just for testing.

173
Views
0
Helpful
3
Replies