Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NTP configuration

hi all,

I made my Core router as NTP router and all other sites as clients but now what i m seeing is that some of those sites are not synchronize with ntp server. I have done also authentication with this server.all sites have same configuration but clock is showing ntp as source but not syn with it. plz tell me what can be the problem .

Second issue is that no. of giants packets are too much on my router. my router connected to switch with different connectivity means router is on fast eth and switch is on giga but both are set to auto speed and full duplex and i m also getting some rx and tx load on both devices . plz help me to rectify the problem.

thanx and regards,

Tarn

1 REPLY
Silver

Re: NTP configuration

Use the show ntp associations command output to determine if NTP is working and communicating properly.

1488
Views
0
Helpful
1
Replies
CreatePlease login to create content