NTP is not working on my cisco WS-C3750E-24TD-Switch
I am trying to configure NTP on my L3 switch but Ntp clock is not synchronized .
My NTP Server is a Window 2003 server machine.The switch is directly connected with server .
I configure the switch as we configure generally.
NTP server ip address(x.x.x.x)
Please suggest the solution....
Please find the attached output of ntp status and ntp association.
System image file is "flash:c3750e-ipbasek9-mz.150-2.SE2.bin"
SWCORE#sh ntp associations de SWCORE#sh ntp associations detail 10.34.226.41 configured, insane, invalid, stratum 2 ref ID 10.34.30.5 , time D7205FB3.CBC85F7F (15:28:11.796 IST Fri May 16 2014) our mode client, peer mode server, our poll intvl 64, peer poll intvl 64 root delay 31.25 msec, root disp 10229.98, reach 377, sync dist 10298.15 delay 1.27 msec, offset 293807.1765 msec, dispersion 15.63 precision 2**6, version 4 org time D72064A2.C3D8C1CD (15:49:14.765 IST Fri May 16 2014) rec time D720637C.F55F4088 (15:44:20.958 IST Fri May 16 2014) xmt time D720637C.F50C0484 (15:44:20.957 IST Fri May 16 2014) filtdelay = 1.27 2.48 2.59 2.63 1.66 5.18 2.58 2.22 filtoffset = 293807. 293797. 293807. 293804. 293809. 293804. 293799. 293807. filterror = 15.63 15.66 15.69 15.72 15.75 15.78 15.81 15.84 minpoll = 6, maxpoll = 10
SWCORE#sh ntp status Clock is unsynchronized, stratum 16, no reference clock nominal freq is 119.2092 Hz, actual freq is 119.2092 Hz, precision is 2**17 reference time is 00000000.00000000 (05:30:00.000 IST Mon Jan 1 1900) clock offset is 0.0000 msec, root delay is 0.00 msec root dispersion is 1596.07 msec, peer dispersion is 0.00 msec loopfilter state is 'FSET' (Drift set from file), drift is 0.000000000 s/s system poll interval is 64, never updated. SWCORE#
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...