Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NTP issue

I have configured the NTP in my network. while i issued the follwoing command its showing 127 pool address..

it suppose to show the NTP server address which i given in my switch right..

Core#sh ntp status

Clock is synchronized, stratum 8, reference is 127.127.7.1

nominal freq is 250.0000 Hz, actual freq is 250.0000 Hz, precision is 2**18 reference time is CCF6449B.32D6EBCE (10:04:43.198 CST Fri Dec 19 2008) clock offset is 0.0000 msec, root delay is 0.00 msec

root dispersion is 0.02 msec, peer dispersion is 0.02 msec

Regards

sateesh kumar.k

3 REPLIES
Cisco Employee

Re: NTP issue

Sateesh,

This is used as the localhost address (i.e. the router is using its own clock for synchronization). The below URL should help

http://www.cisco.com/en/US/products/sw/iosswrel/ps1818/products_tech_note09186a008015bb3a.shtml

Regards,

Arul

*Pls rate all helpful posts*

New Member

Re: NTP issue

Hi,

Thanks for immdiate response..

My questions is y its is showing local host as a NTP as i have given NTP server address?

ntp server 1.1.1.1.

Its suppose to show 1.1.1.1 in NTP status right..

Hall of Fame Super Silver

Re: NTP issue

sateesh

I find that frequently the presence of the 127 address in NTP is because the device is configured with the command ntp master. Have you configured ntp master on this device? If so I suggest that you remove ntp master and see if it then associates with the 1.1.1.1 that you have configured.

HTH

Rick

113
Views
0
Helpful
3
Replies