11-03-2011 06:13 AM - edited 03-07-2019 03:11 AM
I am migrating backbone equipaments.
Now, I have a 6509-E routing backbone and a NX 7000 as a swtich.
Next step is exchange functions.
NX 7000 routing backbone and 6509-E as a slave switch.
Is it enough to set :
ip route 0.0.0.0/0 XXXX,XXXX.XXXX.XXXX
or should I enable any extra feature ?
Thnaks,
Rosa
Solved! Go to Solution.
11-03-2011 06:26 AM
Rosa,
If the NK7 is functioning a Layer-2 device, then that is all you should need. Default route will forward everything to the 6500.
HTH
11-03-2011 06:38 AM
Hi Rosa,
Which device router/switch is handling all routing to that router IP you need to point your default router (gateway last resort).
So in your case if you changed the routing backbone from 6500 to NX7000 then in your 6500 point the default route to the NX7000 IP.
Please rate the helpfull posts.
Regards,
Naidu.
11-03-2011 06:26 AM
Rosa,
If the NK7 is functioning a Layer-2 device, then that is all you should need. Default route will forward everything to the 6500.
HTH
11-03-2011 06:38 AM
Hi Rosa,
Which device router/switch is handling all routing to that router IP you need to point your default router (gateway last resort).
So in your case if you changed the routing backbone from 6500 to NX7000 then in your 6500 point the default route to the NX7000 IP.
Please rate the helpfull posts.
Regards,
Naidu.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide