Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OID does not work

hello ,

I would ask you for this question

Model number                    : WS-C2960G-48TC-L

Please find here below my answers to your questions :

1)     All I know is that the customer is pooling this MIB (1.3.6.1.4.1.9.9.276.1.4) in command line, from a unix station. But, here in our lab, we tried the same thing, using Snmpwalk and it’s not working (NULL value) . For all the others MIB we have tested, it worked fine.

2)     This was tested with the 12.2(44)SE and 12.2(52)SE who are supposed to support this MIB.

3)     From what I know, there are no issues with other OIDs.

Best regards

Hamsofiane

3 REPLIES

Re: OID does not work

Make sure the the interface ID is valid. The actual OID is 1.3.6.1.4.1.9.9.276. What comes next is the interface ID. Soudns liek yours is different than your clients.

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.9.276

Hope it helps.

New Member

Re: OID does not work

Hello ,

Thank you for your response, I tried this with   this OID1.3.6.1.4.1.9.9.276.1.4 but the result is not

good i have a NULL Value.

I do not understand what do you mean about the [What comes next is the interface ID.] can you please

give me an exemple please.

Best regards

Hamsofiane

Re: OID does not work

I walked one of my switches and for that particular switch, my interfaces are indexed starting at 10001. The first valid OID for this switch is  1.3.6.1.4.1.9.9.276.10001. You need to find out what your interface indexes are and then adjust the OID.

You can find the interface indexes with the following command-
show snmp mib ifmib ifindex

Example Output-
FastEthernet0/1: Ifindex = 10001
FastEthernet0/2: Ifindex = 10002
FastEthernet0/3: Ifindex = 10003

As you can see, the interface index from the switch matches my functional OID.

317
Views
0
Helpful
3
Replies