I'm looking for a way to monitor our switches for how much power is being used. I know there is a "show power inline" command, and I've used that many time but I'm looking for a way to monitor it with SNMP. Has anyone found an OID that gives any of the this information?
If I could find one that was power by port, power remaining, or power used it would be helpful.
I've searched and haven't found anything so far.
Right now I'm doing an SNMP walk against a 3560 (our default PoE switch.)
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...