Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

on multilink interface ip load-sharing per-packet in not available

When tring to enable this command i am not geting the per-packet option

7609-2(config)# int mul 11

7609-2(config-if)#ip load-sharing

7609-2(config-if)#ip load-sharing ?

per-destination Deterministic distribution

---------------

Is there any hidden command

dCEF is enabled

Image is 12.2(33)SRA5

Thanks

GK

1 REPLY

Re: on multilink interface ip load-sharing per-packet in not ava

GK,

On the 7600 series, you can only using per-packet load sharing for software switching using the MSFC. You cannot perform per-packet load sharing in hardware.

Hope this helps.

Brandon

280
Views
0
Helpful
1
Replies