Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OS2 on IOS based switches vs CATOS switches

I have one OS2 server and 3 OS2 w/s directly connected to a single switch. The devices can communicate via layer 2 on a 1900 switch as well as a 5500 switch. However I am trying to connect them to a 3560 or a 3745. On the IOS based switches they do not communicate locally. There is no IP whatsoever, and they are all on the same VLAN. Any idea on what causes this?

4 REPLIES

Re: OS2 on IOS based switches vs CATOS switches

Hi,

Please make sure that the switch ports are configured as switch ports "switchport" not layer 3 ports.

HTH, please do rate all helpful posts,

Mohamemd Mahmoud.

New Member

Re: OS2 on IOS based switches vs CATOS switches

Ports are configured as switch ports.

Re: OS2 on IOS based switches vs CATOS switches

Hi,

What is the ports status, make sure that they are configured in the same VLAN and that the VLAN is configured on the switch, and review the speed/duplex config.

HTH,

Mohammed Mahmoud.

New Member

Re: OS2 on IOS based switches vs CATOS switches

Already done. Same vlan, same port/duplex. Ports how as connected, however the devices cannot communicate via layer 2. thanks for the responses.

116
Views
0
Helpful
4
Replies