08-20-2010 07:00 AM - edited 03-06-2019 12:34 PM
Hi,
I want to communicate between these network where are use OSPF with different Area -> RIP -> OSPF, without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 so we can use only one static or default route so How I can?
All ospf have Loopback with RID.
Please help us..
08-21-2010 04:44 AM
if any know how we can do it...???
without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 and how we can make connectivity.
08-21-2010 05:53 AM
Hi Abhinay,
I guess that's for lab testing only, correct? What's the topology look like? How many static routes can we use?
HTH,
Lei Tian
08-23-2010 11:20 PM
08-24-2010 03:50 AM
Hi Abhinay,
I am sure there are other solutions, here is my thought.
on R5
default-information originate alway to ospf
ip summary-address rip 56.56.56.0/24 on fa0/0
on R4
default-information originate always to ospf
ip summary-address rip 0.0.0.0/0 on fa0/1
HTH,
Lei Tian
08-25-2010 06:18 AM
its not done , because we all configure on rip interface can
u please provide the config...
please help us
08-25-2010 10:55 AM
Hi Abhinay,
Here is the configuration I was talking about.
on R5
router ospf x
default-information originate alway
int fa0/0
ip summary-address rip 56.56.56.0 255.255.255.0
on R4
router ospf X
default-information originate always
int fa0/0
ip summary-address rip 0.0.0.0 0.0.0.0
Are you saying you can only make configuration changes on RIP?
HTH,
Lei Tian
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: