Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OSPF and RIP??

Hi,

I want to communicate between these network where are use OSPF with different Area -> RIP -> OSPF, without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 so we can use only one static or default route so How I can?

All ospf have Loopback with RID.

Please help us..

6 REPLIES
New Member

Re: OSPF and RIP??

if any know how we can do it...???

without using GRE, Redistribution, virtual link, PBR, other routing protocol, ipv6 and how we can make connectivity.

Cisco Employee

Re: OSPF and RIP??

Hi Abhinay,

I guess that's for lab testing only, correct? What's the topology look like? How many static routes can we use?

HTH,

Lei Tian

New Member

Re: OSPF and RIP??

Cisco Employee

Re: OSPF and RIP??

Hi Abhinay,

I am sure there are other solutions, here is my thought.

on R5
default-information originate alway to ospf
ip summary-address rip 56.56.56.0/24 on fa0/0

on R4
default-information originate always to ospf
ip summary-address rip 0.0.0.0/0 on fa0/1

HTH,
Lei Tian

New Member

Re: OSPF and RIP??

its not done , because we all configure on rip interface can

u please provide the config...

please help us    

Cisco Employee

Re: OSPF and RIP??

Hi Abhinay,

Here is the configuration I was talking about.
on R5
router ospf x

default-information originate alway
int fa0/0
ip summary-address rip 56.56.56.0 255.255.255.0
on R4
router ospf X

default-information originate always
int fa0/0

ip summary-address rip 0.0.0.0 0.0.0.0

Are you saying you can only make configuration changes on RIP?
HTH,
Lei Tian

572
Views
0
Helpful
6
Replies