Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

OSPF config for the first time

Hi

I have a network with static routes witch I need to convert to OSPF.

Never used OSPF, and do not have much experience in routing in general.

The netvork is connected via some fiber links, but moastly wireless bridges.

I have attached a drawing of how the network is.

Routers are 3550, 3560 and 3750s.

Each router is on a different physical site.

Can anybode explain the best way to solve this?

I will be very greateful.

Everyone's tags (3)
2 REPLIES
VIP Super Bronze

Re: OSPF config for the first time

Hi

You can creat an area 0 and add each router to it

Example for one router

Router OSPF 1

Network 10.10.10.0 0.0.0.255 area 0

In this example 10.10.10.0/24 is the subnet for one of vlan in that router

Do the same for the other routers just different subnets

HTH

Sent from Cisco Technical Support iPhone App

New Member

Re: OSPF config for the first time

Thanks

But shuld all sites be in the same area, when should I devide into different areas?

What about setting cost etc?

340
Views
4
Helpful
2
Replies
CreatePlease to create content