OSPF will definitely treat the EtherChannel as a 3 Gbps link and calculate the Cost accordingly.
Remember that OSPF calculates Cost based on a reference bandwidth of 10 to the 8 (100 million)/configured bandwidth. So, a 100 M FDDi connection defaults to a cost of 1. Anything higher than that will still default to a cost of 1 (since you cannot have a fractional Cost) and nothing will be gained by havin gthat extra bandwidth configured for the interface.
So, to accomodate high-speed links above 100M, use the 'auto-cost reference-bandwidth command while in router configuration mode or use the 'ip ospf-cost' command at the interface to hardcode the Cost.
Good catch. I didnt read his post the way you did. I though tthe final reference bandwidth he configured was 1,000,000 (1M), I didnt think that he may have actually entered "1000000" as the argument in the command itself.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.