Attached is the network diagram we prepared in our lab which is simulating one of our clients network setup. In the above diagram I issued default-information originate command in two routers (ROUTER-01 and SWITCH-01). I am getting one default route each in the other devices with the respective tag. But I am not able to match the route with the tag. I also tried with access-list and prefix-list, which also didn?t work. I am able to see both the default routes in the OSPF database.
Is there any way that we can match both the tags simultaneously and do the manipulation?
we want to manipulate the routes (May be cost) in such a way that one default route is preferred over the other in one area and vice versa in the other area. And in case of failure of one route the second one should be taken.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...