on switch 1 the prefix 192.168.1.0/24 is not advertised. As per show ip route you can see that the switch can work this network only as "Connected" . Advertise it below the OSPF process so to make aware all the infrastructure about it or redistribute the static to 192.168.1.1 below the OSPF process. Do not forget the "subnet" keyword
PS: check the static to 10.10.10.1 ... Do you really need it? that should be an internal OSPF network. Why did you write a static for it?
Thanks for the reply. Why would I need to advertise my 192.168.1.0/24 network? That is technically the "WAN" isn't it? If these 3550's were routers, SW1 would have the connection to the ISP (192.168.1.90) and all the other routers would go through it for the connection to the internet. If they were all routers, I wouldn't advertise my WAN IP, correct?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.