r1-(fr)-r2--r3--r4 (r1-r2:nssa area r2-r3:area 0 r3-r4: normal area XX)
If I want to import default route into all ospf area , how can do use most simple way? I want to config R1(asbr) import,but R2 sometimes cant't translate type 7 0.0.0.0 lsa into TYPE5 , you must use special OSPF mode on frame. who knows why ? or may be use other solution. thanks!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...