Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ospf duplicate interface address

Hello,

 

Configured GNS with two routers connected back to back with Gig interface.

Want to know how does they (ospf) detect this duplicate address.

Run some debug but both routers send hello and stay silent.

 

R1-10.10.10.1-----10.10.10.1--R2

 

R1 router-id: 1.1.1.1

R2 router-id : 2.2.2.2

 

Any clue?

 

Regards # Mahesh

 

Everyone's tags (1)
5 REPLIES
Cisco Employee

 Tested physicall devices and

 

Tested physicall devices and that sends out the duplicate address msg.

Tested on Cisco Packet tracer and I found duplicate msg:

R1--F0/0----f0/0--R2

Router(config)#int f0/0
Router(config-if)#ip address 10.10.10.1 255.255.255.0
Router(config-if)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
%IP-4-DUPADDR: Duplicate address 10.10.10.1 on FastEthernet0/0, sourced by 0001.9786.6601

Router#

 

Could be issue with GNS.

HTH

 

Sorry ! I was looking for how

Sorry ! I was looking for how OSPF detect this. Logically OSPF should struct in Exstart state or no...

Cisco Employee

Yes you are correct.OSPF

Yes you are correct.

OSPF adjacency would not be formed.

It is stuck in Extract state. 

 

HTH

Regards

Inayath

***plz dont forget to rate all usefull posts.

so let me go in bit more

so let me go in bit more detail.

 

Do you have capture which shows it struct in which state. In my case no output entirely.

 

Regards # Mahesh

Cisco Employee

Here are my outputs:Config:R1

Here are my outputs:

Config:
R1 
!
interface FastEthernet0/0
 ip address 10.10.10.1 255.255.255.0
 duplex auto
 speed auto

router ospf 10
 router-id 1.1.1.1
 log-adjacency-changes
 network 10.10.10.1 0.0.0.0 area 0
!

R1#sh ip ospf ne

Neighbor ID     Pri   State           Dead Time   Address         Interface
2.2.2.2           1   EXSTART/DR      00:00:34    10.10.10.1      FastEthernet0/0
R1#

==============R2===========


R2#sh ip ospf ne

Neighbor ID     Pri   State           Dead Time   Address         Interface
1.1.1.1           1   EXSTART/DR      00:00:38    10.10.10.1      FastEthernet0/0
R2#

R2
!
interface FastEthernet0/0
 ip address 10.10.10.1 255.255.255.0
 duplex auto
 speed auto

router ospf 10
 router-id 2.2.2.2
 log-adjacency-changes
 network 10.10.10.1 0.0.0.0 area 0
!

 

HTH

Regards

Inayath

**********Plz dont forget to rate usefull posts****

219
Views
5
Helpful
5
Replies
CreatePlease login to create content