Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ospf info on router

hi all, if I want to see what my hold time and hello timers are for ospf, what do i need to type ?

2 REPLIES
Hall of Fame Super Silver

Re: ospf info on router

Hello Carl,

use

sh ip ospf interface [type x/y]

hope to help

Giuseppe

Community Member

Re: ospf info on router

Hi Carl

Show Ip Ospf interface ... helps you in that case

Router#sh ip ospf interface

Vlan X is up, line protocol is up

Internet Address x.x.x.x/x, Area x Process ID 1, Router ID x.x.x.x, Network Type BROADCAST, Cost: 1

Transmit Delay is 1 sec, State DR, Priority 1

Designated Router (ID) x.x.x.x, Interface address x.x.x.x

No backup designated router on this network

Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5

oob-resync timeout 40

No Hellos (Passive interface)

HTH

Vishal Bhugra

119
Views
0
Helpful
2
Replies
CreatePlease to create content