Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

OSPF over Frame Relay problem !

Hi everybody,

Sr because my English skill is not good so much.

Pls help me to solve the problem like this: I create a network with OSPF point-to-multipoint area 0 run over Frame Relay, and some none-backbone area OSPF run over ethernet. and problem here is: I cannot ping from one ethernet area to the ip of area 0.

The attached file is my config and my network.

I cannot ping from area 1 to area 0, while the ping test from area 3 & area 5 to area 0 are normal.

example:

R6#traceroute 55.0.0.5 source 146.0.0.6

Type escape sequence to abort.
Tracing the route to 55.0.0.5
VRF info: (vrf in name/id, vrf out name/id)
  1 146.0.0.1 12 msec
    146.0.0.4 8 msec
    146.0.0.1 4 msec
  2  *  *  * 
  3  *  *  * 
  4  *  *  * 
  5  *  *  * 
  6  *  *  * 
  7  *  * 

Pls help me !

Thanks so much !

 

Duong Vu

 

 

 

1 REPLY
New Member

Anyone can help me?  Duong Vu

Anyone can help me?

 

 

Duong Vu

148
Views
0
Helpful
1
Replies
CreatePlease to create content