Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ospf priority Question

Hi,

I have the following Lab setup:

Frame Relay Hub and spoke.

NBMA using neighbors. I have a priority of 255 at the hub and under the neighbor command (at the hub) have set the 2 spokes to priority 0. i.e 'neighbor 192.168.1.2 priority 0'. The spokes themselves have a default priority of 1.

The priority at the spoke has overwritten my config at the hub router.

Q: Can you set the priority on the hub for the spokes to 0 ?

Regards,

Phil.

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: Ospf priority Question

"Can you set the priority on the hub for the spokes to 0?"

No. You can specify priority only for routers that are eligible to become the designated router or backup designated router - that is, a router interface with a nonzero router priority value. The default priority value is 0.

HTH

If so, kindly rate this post.

Victor

1 REPLY
Blue

Re: Ospf priority Question

"Can you set the priority on the hub for the spokes to 0?"

No. You can specify priority only for routers that are eligible to become the designated router or backup designated router - that is, a router interface with a nonzero router priority value. The default priority value is 0.

HTH

If so, kindly rate this post.

Victor

103
Views
5
Helpful
1
Replies