i'm starting doing basic ospf lab (image below) , I enable ospf protocol in both DS1 and DS2 router in all interfaces .
according to my own understand of the working routing table , normaly the ping command from DS2 to 192.168.15.1 should work in this scenario .but is not the case , but when we activate ospf in access1 , the ping from DS1 to 192.168.15.1 is Ok
can you explain me why this happen , Why we can't sucess ping in case 1
Most probably, the ping fails because without OSPF, Access1 does not know the route back to 100.100.100.2 when trying to reply. If you run OSPF on Access1, or configure it with a static default route towards DS1, Access1 should be able to respond.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...