i have 3 routers connected to each other like this
R1 ISP R2
i m using a tunnel over ipsec to allow routing via ospf between R1 and R2 everything goes fine, but when the tunnel goes down so does the adjancy, but when the tunnel is up ospf is not making adjancy again automatically !!!! how can i do it ? i want both routers to detect that the tunnel is up and start sending hellos again so that the adjancey is rebuilt but i dont know how, plz tell me
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...