The same network I have designed and working fine on the RIPV2 but I want it on the OSPF but it works on the packet tracer but not on the GNS3. In this diagram there are multiple areas and there are three ABRs connected to the backbone area. The others interfaces are in the area1, area2 and area3 respectfully and in that side I need the intervlan routing.
Is it possible in the ospf the same like in the diagram ?
What type of OSPF (Point to Point or Point to Multipoint ) will be required as the R1 is the backbone router further connected with the Internet on the BGP. ?
1) The link between the ABRs and R1 is the wireless 1.4gig bridge link on the 5Km distand and the interface is configured with IP ospf network point-to-point.
2) On the packet tracer all the neibour displayed with its router-id, even on GNS3 but it does not show the route of other interface like area 1 or area 2.. Means the backbone router do not show the routes of other areas..(area 1 or area 2 and area 3)
3) i have tried alot and i dont think that i missed any route but the backbone area do not show the routes of subnterface (for Vlan, Router on the Stack).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.