need some help here. my situation is a bit complicated.
1. i have a few sites which are interconnected.
2. there are multiple mobile sets of equipment(servers and catalyst 3560 switch) which i need to connect at different sites. (i cant use repeated subnets)
3. i cant change the ip address/subnets/configuration of the servers and switch, when deploying at different sites. (big problem to me)
i was previously looking at IP unnumbered + OSPF to apply on the mobile sets of equipment. but noticed that IP unnumbered on non pt-to-pt interrfaces (which happens to be a 3560) does not work with dynamic protocols.
is there any solutions/alternatives which i can achive mobility on equipment?
It just popped in my head; you can create a VLAN for the mobile equipment, then create a SVI with a IP address designated for the mobile equipment. set the ospf to point to that SVI (virtual int) for the mobile set, have ur devices connect through that VLAN and their permanent ip address, using a SVI as gateway.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...