I want to configure a router so that all the odd IP addresses of a private subnet get NAT'd behind a single public address that's provided by one DSL provider, and then in another ACL all of the even IP addresses in that same private subnet get NAT'd behind a single address that's provided by another DSL provider. After doing the policy NATs I then need to do some kind of policy routing b to the correct next hop based on the new source address (post NAT) Is this possible or is there a better way to do what I'm trying to do ?
Re: Outbound Load Balancing to 2 DSL Providers w/ NAT
You can make use of CEF load balancing, which is based on a combination of source and destination packet information; it allows you to optimize resources by distributing traffic over multiple paths for transferring data to a destination.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...