Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

output drops and loss of connection

Hi All,

My core is a cisco 4507R which is connected to my pix for internet. I am experiencing some pretty severe connection loss. The vlan interface on my core 192.168.10.8 directly connected to the pix internet at 192.168.10.1 cannot ping consistently. When I look at the interface on the 4507R I see a LOT of output dropped packets. At the time of writing this it looks like this:

GigabitEthernet3/3 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet Port, address is 000f.2473.07a2 (bia 000f.2473.07a2)

MTU 1500 bytes, BW 100000 Kbit, DLY 10 usec,

reliability 255/255, txload 42/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s, link type is auto, media type is 10/100/1000-TX

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output never, output hang never

Last clearing of "show interface" counters never

Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 13985536

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 325000 bits/sec, 70 packets/sec

5 minute output rate 16695000 bits/sec, 1466 packets/sec

26433 packets input, 16958019 bytes, 0 no buffer

Received 2 broadcasts (0 multicast)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

1541681 packets output, 2205973562 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

I can only think that the "total output drops" being so high has somethign to do with my connection loss. can someone provide some info?

TIA,

R

1 REPLY
Cisco Employee

Re: output drops and loss of connection

What kind of line card do you have in slot 3 of this 4507R. If its a 48 port gigabit line card, keep in mind that its oversubscribed 8 times.

Also, issue a sh int gig 3/3 counters detail and see if the drops are due to RX-Flowcontrol.

130
Views
0
Helpful
1
Replies
CreatePlease to create content