Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

packet tracer 6 does not support "ip ospf network-type point-to-point"

hi. i'm trying to use this command in packet tracer 6 with OSPF

" ip ospf network-type point-to-point"

but i've noticed that does not work.

anyone knows if it is supported or not ?



2 REPLIES
Cisco Employee

packet tracer 6 does not support "ip ospf network-type point-to-

Not sure of 6. I have 5.3 version and this is working fine there.

Router(config)#int s0/3/0

Router(config-if)#ip ospf network point-to-point

Router(config-if)#exit

Router(config)#

HTH

Regards

Inayath

New Member

packet tracer 6 does not support "ip ospf network-type point-to-

i mean if a try to use it with a LOOPBACK interface, it does not work.

can i create a LOOPBACK interface, and then advertise it, without / 32 in packet ?

that's what i want to do....

970
Views
0
Helpful
2
Replies