Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

packets UnderSize

                   Hi everybody,

Had a question about the rise of packets Undersize when trying to enable a  802.1q  trunk on Catalyst 3750, the other side is a Blade  server BL6000, T4-1B.

My IOS version is C3750E Software (C3750E-UNIVERSALK9-M), Version 12.2(55)SE3

#sh int gi 3/0/17 counters errors

Port        Align-Err    FCS-Err   Xmit-Err    Rcv-Err UnderSize
Gi3/0/17            0          0          0          0     70220

Any help would be welcome.

Everyone's tags (2)
3 REPLIES
VIP Purple

packets UnderSize

Hi,

This may be being caused by duplex mismatch on the Gigabit interfaces.

Can you

show interface g3/0/17 status

at both ends of your links

Regards

please rate if it helps.

packets UnderSize

Hi m-garay,

i would suggest to read this document:

https://supportforums.cisco.com/docs/DOC-2809

and to perform an extended ping varying the size of your packet to realise which is the max size you can send over the network. Remeber that the MTU won't be anymore 1500 because some headers are added while sending the frame out. generally you should reverify and set MTU to 1522 and to optimize the mss too.

to really check the undersize packets look for the number of "runts" with show interface gigx/y

HTH

Alessio

packets UnderSize

m-garay wrote:

                   Hi everybody,

Had a question about the rise of packets Undersize when trying to enable a  802.1q  trunk on Catalyst 3750, the other side is a Blade  server BL6000, T4-1B.

My IOS version is C3750E Software (C3750E-UNIVERSALK9-M), Version 12.2(55)SE3

#sh int gi 3/0/17 counters errors

Port        Align-Err    FCS-Err   Xmit-Err    Rcv-Err UnderSize
Gi3/0/17            0          0          0          0     70220

Any help would be welcome.

Hello,

As stated aove most common cause of the undersize rames can be caused by collisions.  Please check your speed & duplex settings.  Could also be a cabling issue. 

Hope that Helps

Ganehh Iyer

739
Views
0
Helpful
3
Replies