I want to create an Etherchannel with two ports, but I would like than one port carry more traffic than the other. Is this possible? I've seen there is a "priority" command in the pagp configuration to assign port priority, but I am not sure if this works like I would like to...
You can't really control the load-balancing as such. You can configure which type of load balancing it will do ie. src/dst mac address, source/dst IP address, port numbers but not all switches support all types.
The Pagp priority command does not affect which link is used for load-balancing.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.