Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Silver

Part number for PCMCIA flash card to fit C6K supervisor II?

I'm trying to find out what the part number is for the flash card that fits in the front panel slot on a C6K supervisor 2 card. I cannot located this information on Cisco.com, so can I do this, and if so can anyone tell me the part number?

Andy

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Part number for PCMCIA flash card to fit C6K supervisor II?

Hi there,

I've found a document that lists the following part numbers :

MEM-C6K-FLC16M(=)

MEM-C6K-FLC24M(=)

MEM-C6K-FLC64M(=)

MEM-C6K-ATA-1-64M(=)

The document notes that the ATA flash module is compatible with "Catalyst 6500 series switches running Catalyst software release 7.5(1) or later releases on the supervisor engine and Cisco IOS on the MSFC."

It also mentions that "The 64-MB ATA Flash PC card (MEM-C6K-ATA-1-64M) requires Supervisor Engine 2 with ROMMON software release 7.1(1) or later releases".

So it looks like the ATA 64-MB card is the one you need, assuming you have the correct ROMMON version installed.

Here's the URL:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/6507_01.html

Hope this helps!

Kind regards

Graeme

2 REPLIES

Re: Part number for PCMCIA flash card to fit C6K supervisor II?

Hi there,

I've found a document that lists the following part numbers :

MEM-C6K-FLC16M(=)

MEM-C6K-FLC24M(=)

MEM-C6K-FLC64M(=)

MEM-C6K-ATA-1-64M(=)

The document notes that the ATA flash module is compatible with "Catalyst 6500 series switches running Catalyst software release 7.5(1) or later releases on the supervisor engine and Cisco IOS on the MSFC."

It also mentions that "The 64-MB ATA Flash PC card (MEM-C6K-ATA-1-64M) requires Supervisor Engine 2 with ROMMON software release 7.1(1) or later releases".

So it looks like the ATA 64-MB card is the one you need, assuming you have the correct ROMMON version installed.

Here's the URL:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/6507_01.html

Hope this helps!

Kind regards

Graeme

Silver

Re: Part number for PCMCIA flash card to fit C6K supervisor II?

Thanks Graeme, that was exactly what I was looking for.

Andy

297
Views
0
Helpful
2
Replies
CreatePlease to create content